Safety Regulations - DKL CHAIRS D2-SOLO Gebrauchsanweisung

SAFETY REGULATIONS

- The function of the ALYA dental light is to illuminate the oral cavity of the
- The light must be used by qualified staff.
- The articulated arm and head joint ensure that the light beam is correctly posi-
- Installation of the system must only be performed by specialized staff.
- Check that the power voltage, shown on the data plate, corresponds to the mains
- Do not block the light beam for patients at risk (i.e. with eye conditions). Use
- Information plate with LED indications fixed to the rear arm.
- The dental light must be installed on a specific control and supply device, such
- The device must be installed with an omnipolar shut-off switch that disconnects
- Do not carry out any maintenance work when the power is on; disconnect the
- Do not introduce items or tools into slits in the light head that could touch live points.
- Patients at risk (e.g. children with eye diseases) must not stare at the light beam.
- Not suitable for installation in environments containing flammable gas.
- Do not spray detergents-disinfectants directly on the head.
- Inadequate performance of the system does not in any way compromise the
- For cleaning plastic parts of the lamp ALYA, DO NOT USE detergents-
- Do not carry out maintenance or replacement work on parts other than those
- Disinfect surfaces with hydroalcoholic disinfectants.
- Do not leave small parts unattended or within the reach of exposed persons
- The dentist is obliged to used the disposal protection sleeves on the handles of
- Divide materials according to their type (e.g. iron, rubber, plastic.). When scra-
- The packaging of the light is suitable for protecting it from the penetration of
- The system in its original packaging can be transported or kept in storage for a
- The system must be used in the following environmental conditions:
12
patient during dental operations.
tioned. Do not overload the arms and joints with impact on the limit switches.
voltage.
correct protection and precautions.
as a dental unit, or with an electrical system that complies with standard
IEC 364-1 and "national regulations for installation of electrical systems in
areas for medical use".
it from the mains and is conformant to IEC/EN 61058. It is necessary to install
a green signal light to indicate when the lamp is switched on.
power cable from the mains beforehand.
Always use appropriate protection devices and precautions. Faro suggests using
the protective eyeware BLUE-BAN or BABY BLUE-BAN (for children).
safety of the patient.
disinfectants containing:
HYDROXIDE – METHYLENE CHLORIDE – METHYL ALCOHOL. Failure
to comply with this indication might cause: • risk of breakage of plastic
parts.
shown in the manual. Any operation not indicated in the manual could compro-
mise the safety aspect of the device.
(children); they could be potential sources of danger.
the lamp or ensure that versions without this possibility are sterilized.
ping and disposing of the materials, comply with the current legislation of your
country, and if necessary use recognized and authorized specialist companies.
external agents.
period of 15 weeks if the following environmental conditions are observed:
- Ambient temperature from –20° C to + 70°C
- Relative humidity from 10% to 90%
- Atmospheric pressure from 500 to 1060 mBar
- Temperature from 10° to 40°C
- Relative humidity from 30 to 75%
- Atmospheric pressure from 700 to 1060 mBar
AMMONIUM HYDRIXIDE – SODIUM