Installing The Led Strip - LIVARNO LUX IAN 345123 2004 Montage-, Bedienungs- Und Sicherheitshinweise

Check the correct positioning.
You may also connect the LED strip
To do this, repeat the steps in the chapter "Trimming / connecting
the LED tape". Please note Figure F for this purpose.
Be sure to cover the open end of the LED tape
sive strip
20
the tape (see Fig. G).

Installing the LED strip

Note: Ensure that the installation area is clean, grease-free and dry.
Otherwise the functionality of the adhesive strip may be impaired.
Note: Ensure that a plug socket is located in close proximity to the
installation area.
Choose a suitable installation area.
Using the plug
cket on the receiver
6
Now connect the LED strip
to the arrow marking and the polarity (+12 V DC) on the LED strip
(see partial view in Fig. A).
3
Remove the protective film from the reverse side of the LED strip
(see Fig. B).
Stick the LED strip
strip and press it on firmly (see Fig. B).
Remove the protective film from both sides of the adhesive strip (re-
ceiver) and stick this to the back of the receiver
15
Stick the receiver
Screw down the receiver
Remove the protective film
holder (see Fig. D).
14
if you do not wish to connect the end after trimming
, connect the mains cable
7
(see Fig. A).
16
3
onto the installation area using the adhesive
3
to the desired location.
16
using the screws
16
13
with the 4-way divider
3
1
with the receiver
17
from the reverse side of the cable
18
with the adhe-
3
directly to the so-
. Pay attention
16
3
(see Fig. E).
16
.
GB/IE
.
35