Initial Use; Inserting / Replacing Batteries; Trimming The Led Tape; Installing The Led Strip - LIVARNO LUX IAN 339471 1910 Bedienungs- Und Sicherheitshinweise

Leaked or damaged batteries / rechargeable
batteries can cause burns on contact with the
skin. Wear suitable protective gloves at all
times if such an event occurs.
In the event of a battery leak, immediately
remove it from the product to prevent damage.
Only use the same type of batteries / recharge-
able batteries. Do not mix used and new
batteries / rechargeable batteries.
Remove the batteries / rechargeable batteries if
the product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery /
rechargeable battery!
When inserting ensure the correct polarity!
This is shown inside the battery compartment!
Clean the contacts on the battery and in the
battery compartment before inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.

Initial use

Remove all packaging materials before first use.

Inserting / replacing batteries

Slide the battery cover
the arrow and remove it.
Insert the batteries into the battery compart-
ment while taking the polarity into account
2
(+ and -).
Only use batteries
"Technical Data."
Slide the battery cover
opposite direction to the arrow.
Hint: Make sure that the battery cover
securely locked in place.
in the direction of
4
specified in the chapter
3
back on in the
4
4
Safety / Initial use / Installing the LED strip

Trimming the LED tape

The LED strip can be trimmed.
ELECTRIC SHOCK!
Before doing any work on the LED strip
the batteries
3
Choose the desired LED strip length.
Note: Ensure that you cut the LED strip at the
right place. The cutting point lies exactly be-
tween the plus and minus pole and is marked
with a black line.
Shorten the LED strip
Be sure to cover the open end of the LED strip
with the adhesive strip

Installing the LED strip

Note: Ensure that the installation area is clean,
grease-free and dry. Otherwise the functionality of
the adhesive strip may be impaired.
Choose a suitable installation area (window etc.).
Remove the protective film
side of the LED strip
Note: When removing the protective film
make sure to start from the side of the supply
cable. Make sure that you do not also peel
away the adhesive coating when removing the
protective film
Stick the LED strip
onto the installation area and press it on firmly.
Remove the protective film from the adhesive
strip on the reverse side of the battery com-
5
partment
2
Stick the battery compartment
installation surface.
Note: Make sure that the sliding switch
is can be operated.
Ensure that the motion sensor
movement.
Your lamp is now ready to use.
DANGER TO LIFE BY
from the battery compartment
using a pair of scissors.
9
before use (see fig. A).
10
from the reverse
8
.
9
.
8
with the adhesive strip
9
.
to the
2
can detect
7
remove
9
.
2
9
,
8
1
GB/IE 17