Replacing / Inserting Batteries; Trimming / Connecting The Led Tape - LIVARNO LUX IAN 345123 2004 Montage-, Bedienungs- Und Sicherheitshinweise

Replacing / Inserting batteries

Note: Before first use, pull the insulating strip
tery compartment
If the range of the remote control
needs to be replaced. To do so, slide the battery compartment out
of the remote control
new one.
Note: The correct polarity is indicated on the reverse side of the
remote control
Slide the battery compartment

Trimming / connecting the LED tape

The LED tape may be trimmed to size or connected.
Disconnect the lights from the power supply before performing any
work on the LED strip
socket to do so.
Choose the desired LED strip length.
Note: Ensure that you trim the LED strip at the right place. The
cutting point is exactly in the middle of the poles and is marked
with a black line (+ 12 V DC, DI, GND, GND) (see Fig. C).
Trim the LED strip
Then press both ends of the LED strip
contact of the plug connection
the LED strips
nector (+12 V DC, DI, GND, GND) and to the arrow markings on
the LED strip
(see Fig. C).
Then press one end cap
connection
34 GB/IE
.
8
. Remove the old battery
4
.
4
DANGER TO LIFE BY ELECTRIC SHOCK!
. Unplug the mains adapter
3
using a pair of scissors.
3
, pay attention to the correct polarity of the con-
3
. The imprinted arrows must point in one direction
3
at a time onto the ends of the plug
12
(see Fig. C).
11
(see Fig. A)
9
reduces, the battery
4
back into the remote control
8
onto the displacement
3
(see Fig. C). When connecting
11
out of the bat-
10
and insert a
10
.
4
from the
2