Prior To Installation; Initial Use; Installing The Light On The Ceiling / Wall; Changing The Light Bulb - LIVARNO LUX IAN 306755 Montage-, Bedienungs- Und Sicherheitshinweise

– Pencil /marking tool
– Voltage tester
– Screwdriver
– Electric drill
– Drill
– Hammer
– Ladder

Prior to installation

Important: The electrical connection must be
performed by a trained electrician or a person
instructed in electrical installation. This person must
be familiar with the properties of the light and
connection regulations.
Note: Remove all packaging material before first
use.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the
light itself, before you install it.
Before installation ensure that the circuit to which
the light will be connected is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 setting).
Use the voltage tester to verify it is de-ener-
gised.

Initial use

Installing the light on the
ceiling / wall
Screw the lamp glass
from the light fixture
Mount the light fixture
tion. Bear in mind the drill hole
fixture through which the power cable will
3
be inserted (see Fig. B). Mark the drill holes
with a pencil.
Drill the holes and ensure that you do not dam-
age the mains connection cable
Insert the dowels in the drilled holes. If neces-
sary, use a hammer.
counter-clockwise
2
.
3
in the desired posi-
3
in the light
10
.
6
Guide the mains connection cable through the
seal of the opening in the light fixture
11
(see Fig. B).
Attach the mains connection cable under the
cable bridge using the two screws
7
(see Fig. C).
Note: Ensure that you insert and screw down
the individual house wiring cables according to
the colours given in the lamp terminal
wire: black or brown, symbol L; neutral wire,
blue, symbol N; protective earth wire:
green-yellow).
Note: The LED ceiling light
protective insulation. The protective conductor
does not have to be connected and can remain
loose in the LED ceiling light
Remove the blue protective film from the alumi-
nium reflector.
Screw the LED lamp
the light (see Fig. D)
Screw the lamp shade
light fixture (see Fig. E).
3
Replace the fuse or switch on the circuit
breaker in the fuse box (I setting).

Changing the light bulb

Note: Only replace the light bulb when the LED
ceiling light has been disconnected from the
1
power supply and the light bulb has cooled down
to prevent burns.
Disconnect the LED ceiling light
power supply by removing the fuse to interrupt
the circuit.
Wait approx. 3 minutes until the LED ceiling
light has cooled down.
1
Screw the lamp glass
from the light fixture
Insert the new LED light bulb.
Screw the lamp glass
light fixture and ensure that it is secure.
3
Switch the fuse back on and check that the LED
ceiling light functions.
1
3
: live
9
features
1
.
1
into the lamp socket in
4
clockwise onto the
2
from the
1
counter-clockwise
2
.
3
clockwise onto the
2
GB/IE/NI 9