Mounting The Light; Start Of Operation; Using The Led Night Light; Replacing Batteries - LIVARNO LUX Z31685A Bedienungs- Und Sicherheitshinweise

Mounting the light

Note: You will need an electric drill to install the light.
CAUTION! RISK OF INJURY! Refer to the operating instructions
for your electric drill.
CAUTION! Ensure that you do not damage any cables in the wall.
Please see figure A (with screws and dowels) or B
(with adhesive tape) for mounting the light.
Note: The substrate should be dry, smooth and free of dust
and grease.
Note: For the first 24 hours after installation do not remove
the self-adhesive pad. Otherwise the self-adhesive pad will
lose its ability to stick.

Start of operation

Using the LED night light

Note: Before first use remove the insulation strip.
Note: For model Z31685A, slide the ON / OFF switch
ON position before start of operation.
The light will automatically switch on when motion is detected
in a dark environment.
The light will automatically switch off when motion is no
longer detected for a period of time.

Replacing batteries

Open the battery compartment at the back of the device.
Remove the old batteries and insert new batteries (see Fig C).
Check the polarity of the batteries. This is shown in the battery
compartment.
Close the battery compartment.
10 GB/IE/NI
to the
8