Main Ten An Ce; Gen Eral Notes; Main Te Nance Sched Ule - Ammann APH 110-95 Betriebsanleitung

6. Main ten an ce

6.1 Gen eral notes

Care ful main te nance:
in creased ser vice life
in creased func tion se cu rity
re duced downtimes
in creased re li abil ity
re duced re pair costs
• Ob serve the safety reg u la tions!
• Main te nance works should only be car ried out when the
en gine is shut off.
• The en gine and ma chine should be cleaned thorougly be -
fore car ry ing out main te nance work.
• Park the ma chine on a flat sur face and se cure it against
roll ing away and slip ping.
• En sure that op er at ing ma te ri als and re placed parts are dis -
posed of safely and in an en vi ron men tally-friendly way.

6.2 Main te nance sched ule

Main te nance works
Clean ma chine
1)
Check en gine oil level
1)
Change en gine oil
1)
Change en gine oil fil ter
1)
Check air fil ter
1)
Change air fil ter el e ment
1)
Change fuel fil ter
Fuel sys tem: Drain con den sa tion
In spect ra di a tor hoses and clamps
1)
In spect the air in take line
1)
Clean wa ter trap
1)
Clean fuel tank
1)
Change V-belt
Cle an cooler
Ex citer: Check oil level
2)
Ex citer: Change oil
Check hy drau lic oil level
2)
Change hy drau lic oil
2)
Change re turn fil ter el e ment
2)
Change ven ti la tion fil ter
2)
Clean suc tion fil ter
Check the hy drau lic hose lines
Check rub ber buff ers
Check screwed con nec tions for
tight ness
1)
See en gine op er at ing man ual
2)
min i mum once a year
3)
for the first time
In ter vals
Daily 20 h
3)
3)
1)
1)
3)
3)
• Be fore com menc ing work on any elec tri cal equip ment,
dis con nect the bat tery and cover it with in su lat ing ma te -
ri als.
• Do not ex change «PLUS» and «MINUS» poles on the bat -
tery.
• It is es sen tial that short-cir cuits be pre vented in ca bles
car ry ing cur rent.
• Be fore weld ing works on the ma chine put-off all con nec -
tions and bat tery ca bles.
• Burn-out lightbulbs in in di ca tor lamps should be re -
placed im me di ately.
• When clean ing the ma chine with a high-pres sure wa ter
jet, do not spray the elec tri cal com po nents di rectly.
• Af ter wash ing the com po nents, blow-dry them with com -
pressed air in or der to pre vent sur face leak age cur rent
and cor ro sion.
50 h 100 h 200 h
3)
59
400 500 h 1000 h
3)
3)
3)
If nec es -
sary