Safety Instructions - HBM U10M Montageanleitung

Safety instructions

1 Safety instructions
Intended use
The force transducers of the U10M/U10S type series are solely designed for
measuring static and dynamic tensile and/or compressive forces within the load
limits stated in the specifications for the respective maximum capacities. Any
other use is not appropriate.
To ensure safe operation, the regulations in the mounting and operating in­
structions, together with the following safety rules and regulations, and the data
specified in the technical data sheets, must be complied with. It is also essen­
tial to observe the applicable legal and safety regulations for the application
concerned.
The force transducers are not intended for use as safety components. Please
also refer to the "Additional safety precautions" section. Proper and safe opera­
tion of force transducers requires proper transportation, correct storage, setup
and mounting, and careful operation.
Load-carrying capacity limits
The information in the technical data sheets must be complied with when using
force transducers. The respective specified maximum loads in particular must
never be exceeded. The following limits set out in the technical data sheets
must not be exceeded:
S Force limits
S Lateral force limits
S Bending moment limits
S Torque limits
S Breaking forces
S Permissible dynamic loads
S Temperature limits
S Limits of electrical loading capacity
Please note that when several force transducers are
interconnected, the load/force distribution is not always uniform.
4 U10M/U10S
A01385_06_YIC_06 HBM: public