HBM U10M Montageanleitung Seite 12

Scope of supply and equipment variants
Cables/plugs
Knuckle eye, M42x2 internal thread
Knuckle eye, M72x2 internal thread
Equipment variants
All force transducers are available in different versions. The following options
are available:
1. Nominal (rated) force:
You can purchase nominal (rated) forces from 1.2 5 kN to 1.2 5 MN.
2. Double bridge design
The force transducer is also available with two electrically isolated
measurement bridge circuits.
3. Adjusted rated output
On request, we can adjust the rated output of your U10M to exactly match
the nominal rated output. In sensors with nominal (rated) forces 1.25 kN,
2.5 kN and 5 kN, the output signal at nominal (rated) force is then 1 mV/V,
in all other force transducers it is 2 mV/V. These values apply together with
100% calibration (standard). If you choose the 200% calibration option, the
output signal doubles. If you order the "adjusted rated output" option, the
output resistance is always adjusted as well, so that several sensors can be
connected in parallel. (Exception: nominal (rated) force 1.25 MN is not suit­
able for parallel connection)
4. Calibration
On request, HBM can calibrate the force transducer to 200% nominal
(rated) force. The high mechanical reserves of the force transducer make
this application possible in measurement tasks with a limited oscillation
bandwidth (see Specifications). But be aware that when double the force is
measured, the output signal also doubles.
5. TEDS transducer identification
You can purchase the force transducer with transducer identification
("TEDS"). TEDS (Transducer Electronic Data Sheet) allows you to store the
transducer data (rated outputs) in a chip, that can be read out by a con­
10
A01385_06_YIC_06 HBM: public
Ordering number
1-ZGIM42F
1-ZGIM72F
U10M/U10S