HBM U10M Montageanleitung Seite 22

Mechanical installation
M16
22
16,5 f7
M16
A
You do not need to pay attention to this information if measurement takes
place at uniform temperatures or taring is possible before changes in tempera­
ture. Likewise, large nominal (rated) forces above 25 kN are not affected.
The screwed-in force application parts must be sufficiently pre-stressed to
meet the stated specifications and the full endurance strength of the threads.
This is implemented with a locknut screwed onto the customer-side structural
element. We recommend using one of the methods described below.
1. Pre-stressing with defined tightening torque
Force transducers with a nominal force up to and including 25 kN can be
mounted using this method.
S Screw the force application part into the transducer or adapter as far as the
retainer.
S Unscrew force application part two revolutions.
S Pre-stress force application part with defined tightening torque.
20
A01385_06_YIC_06 HBM: public
min. 22
16,5 f7
0,02
M16
A
2:1
A
0,03 A
U10M/U10S