Appendix; Questions And Answers - Unify OpenScape DECT Phone S6 Base Bedienungsanleitung

Questions and answers

Questions and answers
Troubleshooting
The display is blank.
•
The handset is not activated.
•
The battery is empty. Charge the battery or replace it
"No Base" flashes on the display.
•
The handset is outside the range of the base station.
•
The base is not activated.
•
The base station's range is reduced because Maximum Range is deactivated. ¥
Activate Maximum Range or reduce the distance between the handset and base station
"Please register handset" flashes on the display.
•
The handset has not yet been registered or was de-registered due to the registration of an additional
handset (more than 6 DECT registrations).
Your settings are not accepted.
•
The wrong profile has been set.
The handset does not ring.
•
The ringtone is deactivated.
•
Call forwarding is set. Deactivate call forwarding.
•
The phone does not ring if the caller has withheld his number.
¥
Activate the ringtone for anonymous calls.
•
The phone does not ring during a specific period or for certain numbers.
¥
Check the time control for external calls
No ringtone/dial tone from the fixed line network.
•
Incorrect phone cable. Please always use the phone cable supplied or ensure that the pin connections
are correct when purchasing from a retailer.
The connection always terminates after approx. 30 seconds.
•
A repeater (earlier than Version 2.0) has been activated or deactivated.
on again.
Error tone sounds after system PIN prompt.
•
You have entered the wrong system PIN.
Forgotten system PIN.
¥
Reset the system PIN to 0000
The other party cannot hear you.
•
The handset is "muted". Activate the microphone again
Some of the network services do not work as specified.
•
Features are not enabled.
130

Appendix

Press and hold .
Move the handset closer to the base station
Check the base station power adapter
Re-register the handset
Set Profile Personal . . . then make changes to the device settings.
Activate ringtone
Repeat the process, reset the system PIN to 0000 if required
Contact the network provider for details.
Switch the handset off and back