Microphone Sensitivity - Unify OpenScape DECT Phone S6 Base Bedienungsanleitung

¤
Adjust the sensor:
¤
Save:
Headset – volume correction
Change the call volume for the wired headset. In addition to the standard settings for the call
volumes, here you can compensate the audio setting characteristics of your headset.
¤
. . . Use to select
to set the volume Save

Microphone sensitivity

Adjust the sensitivity of the microphone for the receiver or wired headset. This gives you
improved acoustics in loud environments and when there are echoes.
¤
. . . Use to select
select what the setting applies for (Earpiece / Corded headset)
sensitivity Save
Earpiece and handsfree profile
Select a profile for the earpiece and handsfree mode in order to adapt the telephone as much
as possible to the surroundings. Check which is the most comfortable profile for you and your
caller.
¤
. . . use to select
Earpiece Profiles / Handsfree Profiles
Select ( = selected)
Earpiece Profiles: High frequency or Low frequency (default setting)
Handsfree Profiles: Standard (default setting) or Reduced Echo
Ringtones
Ringtone volume
¤
. . . use to select
Ringtones (Handset)
to select For internal calls and alarms or External Calls
use to set volume in 5 levels or in crescendo mode
(increasing volume) Save
Changes are only saved permanently in Profile
Personal.
Sensitivity Use to adjust the sensor sensitivity
Save
Audio Settings OK
Audio Settings OK
Audio Settings OK
OK use
Audio Settings OK
OK Volume OK use
Handset
Corded Hdst Boost Use
Mic Sensitivity OK Use
Use to adjust the
Acoustic Profiles
to select profile
Example
Volume
For internal calls
and alarms:
<
External Calls:
Back Save
to
>
123