Alarm Clock; Switching Off/Repeating The Alarm After An Interval (Snooze Mode) - Unify OpenScape DECT Phone S6 Base Bedienungsanleitung

Alarm clock

¤
Save the timer:
The timer starts the countdown. In the idle display, icon
minutes are displayed until one minute is left. From this point, the remaining seconds are
counted down. At the end of the countdown, the alarm is triggered.
Disabling/repeating the alarm
¤
Switch off the alarm:
¤
Repeat the alarm:
Alarm clock
Date and time have been set.
Activating/deactivating the alarm clock and setting the wake-up time
¤
. . . use to select
¤
Switch on/off:
Setting the wake-up time:
¤
¤
Set days:
¤
Set the volume:
¤
Set alarm:
¤
Save settings:
When the alarm clock is activated, the icon
display.
Alarm
An alarm is shown on the display and indicated by the selected ringtone melody. The alarm
sounds for 60 seconds. If no key is pressed, the alarm is repeated after 5 minutes. After the
second repetition, the alarm call is deactivated for 24 hours.
During a call, the alarm is only indicated by a short tone.

Switching off/repeating the alarm after an interval (snooze mode)

Deactivate the alarm: OFF
Repeat the alarm (snooze mode):
repeated after 5 minutes.
106
Save
OFF
Restart . . . the timer display is displayed again
duration as required Save . . . the countdown is restarted
Organizer OK
Activation: . . . use to select On or Off
Time . . . use to enter hours and minutes
Occurrence . . . use
and Daily
Volume . . . use to set volume in 5 levels s or select
crescendo (increasing volume)
Melody . . . use to select a ringtone for the alarm
Save
and the wake-up time are displayed in idle
Press Snooze or any key . . . the alarm is switched off and
and the remaining hours and
set another
Alarm Clock OK . . . then
to switch between Monday-Friday