Operation With A Pabx - Unify OpenScape DECT Phone S6 Base Bedienungsanleitung

Operation with a PABX

As soon as a repeater is registered, it will appear in the repeater list under
Settings System Repeater
De-registering a repeater
¤
. . . use to select
. . . use to select repeater
Operation with a PABX
To find out which settings are required for a PABX, please refer to the PABX user guide.
Setting Tone or Pulse dialling mode
¤
. . . use to select
Mode OK . . . use
Setting the flash time
¤
. . . use to select
. . . possible flash times are listed
Saving an access code (outside line code)
Setting the access code (e.g. "0") for dialling using the fixed line network.
¤
. . . use to select
Code OK . . . then
¤
Fixed line network:
¤
Rule:
¤
Save:
Setting pauses
¤
Pause after line seizure:
118
Settings OK System
De-reg. Yes
Settings OK
to select Tone or Pulse Select (
Settings OK Telephony
. . . use to select flash time
Settings OK Telephony
Access external line with: . . . use
code, max. 3 digits
For . . . use to select when the access code should be
dialled
Call Lists: The access code will only prefix numbers from a list (list
of answered calls, list of missed calls).
All calls: The access code prefixes all numbers dialled.
Off: The access code is deactivated and does not prefix any
telephone number.
Save
. . . then
¤
1 sec
¤
3 secs
¤
7 secs
OK Repeater
Telephony OK Dialling
= selected)
OK Recall
Select ( = selected)
OK Access
to enter or change access
OK
OK
OK
OK
OK