Additional Safety Instructions - Scheppach 5906136901 Original Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

- Rubber gloves and non-slip shoes are recom-

mended when working outdoors.

- Tie long hair back in a hair net.

8. Do not use the cable for purposes for which it is

not intended

- Do not use the cable to pull the plug out of the

outlet. Protect the cable from heat, oil and sharp

edges.

9. Take care of your tools

- Keep your compressor clean in order to work

well and safely.

- Follow the maintenance instructions.

- Check the connection cable of the electric tool

regularly and have it replaced by a recognised

specialist when damaged.

- Check extension cables regularly and replace

them when damaged.

10. Pull the plug out of the outlet

- During non-use of the electric tool or prior to

maintenance and when replacing tools such as

saw blades, bits, milling heads.

11. Avoid inadvertent starting

- Make sure that the switch is switched off when

plugging the plug into an outlet.

12. Use extension cables for outdoors

- Only use approved and appropriately identified

extension cables for use outdoors.

- Only use cable reels in the unrolled state.

13. Remain attentive

- Pay attention to what you are doing. Remain

sensible when working. Do not use the electric

tool when you are distracted.

14. Check the electric tool for potential damage

- Protective devices and other parts must be care-

fully inspected to ensure that they are fault-free

and function as intended prior to continued use

of the electric tool.

- Check whether the moving parts function

faultlessly and do not jam or whether parts are

damaged.

- All parts must be correctly mounted and all

conditions must be fulfilled to ensure fault-free

operation of the electric tool.

- Damaged protective devices and parts must be

properly repaired or replaced by a recognised

workshop, insofar as nothing different is speci-

fied in the operating manual.

- Damaged switches must be replaced at a cus-

tomer service workshop.

- Do not use any faulty or damaged connection

cables.

- Do not use any electric tool on which the switch

cannot be switched on and off.

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

15. Have your electric tool repaired by a qualified

electrician

- This electric tool conforms to the applicable

safety regulations. Repairs may only be per-

formed by an electrician using original spare

parts. Otherwise accidents can occur.

16. Important!

- For your own safety you must only use the ac-

cessories and additional units listed in the oper-

ating instructions or recommended or specified

by the manufacturer. The use of mounted tools

or accessories other than those recommended

in the operating instructions or catalogue may

place your personal safety at risk.

17. Noise

- Wear ear muffs when you use the compressor.

18. Replacing the power cable

- To prevent hazards, leave the replacement of

damaged power cables strictly to the manufac-

turer or a qualified electrician. There is a risk of

electric shock!

19. Inflating tires

- Directly after inflating tires, check the pressure

with a suitable pressure gauge, for example at

your filling station.

20. Roadworthy compressors for building site oper-

ations

- Make sure that all lines and fittings are suitable

for the maximum permissible operating pressure

of the compressor.

21. Place of installation

- Set up the compressor on an even surface.

22. Supply hoses at pressures above 7 bar should be

equipped with a safety cable (e.g. a wire rope).

23. Avoid over-stressing the piping system by using

flexible hose connections to prevent kinking.

24. Use a residual current circuit breaker with a trig-

ger current of 30 mA or less. Using a residual cur-

rent circuit breaker reduces the risk of an electric

shock.