Clutch Control - SWM VAREZ 125 Handbuch - Gebrauch - Wartung

CLUTCH CONTROL

The clutch control lever (1) is located on the left-hand
side of the handlebar and is equipped with a protection.
The clutch control position on the handlebar can be
-
adjusted by loosening the retaining screws (2).
CAUTION
Do not forget to tighten the screws (2)
after adjustment.
18
EN -
REAR BRAKE CONTROL
The rear brake control pedal (1) is placed on the right-
hand side of the motorcycle. A stop switch, during the
braking action, causes the stop light on the tail light
to come on.
GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the engine.
The rider must release the lever after each gear change
to allow it to return to its central position. Neutral
position (N) is between the first and second gears.
First gear is engaged by pushing the lever downwards;
the other gears are engaged in a sequence by pushing
the lever upwards.
The lever position can be adjusted using the relevant rod,
after loosening the relevant nuts (2pcs).
Tighten the screw once operation is completed.
WARNING
Do not downshift when travelling at a
speed that would force the engine to "over-
rev" or cause the rear wheel to lose grip, if
the immediately lower gear is selected.
CAUTION
Do not shift gears without disengaging the
clutch and closing the throttle. The engine
could be damaged by "over-revving".
6 6
5
4
3
2
N
1
1