Clutch Control - SWM RS 125 R 2020 Handbuch - Gebrauch - Wartung

CLUTCH CONTROL

The clutch control lever (1) is located on the left-hand
side of the handlebar and is equipped with a protection.
The clutch control position on the handlebar can be
adjusted by loosening the retaining screws (A).
CAUTION
Do not forget to tighten the screws (A)
after adjustment.
16
EN -
COMBINED BRAKING CONTROL
The combined braking control pedal (1) is placed on
the right-hand side of the motorcycle. A stop switch,
during the braking action, causes the stop light on the
tail light to come on.
Note
Pull the lever (2) to brake with the front brake; press
the pedal (1) for a combined braking in which the
system distributes braking on both front brake and
rear brake.
GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the
engine. The rider must release the lever after each
gear change to allow it to return to its central position.
Neutral position (N) is between the first and second
gears.
First gear is engaged by pushing the lever downwards;
the other gears are engaged in a sequence by pushing
the lever upwards.
The lever position on the shaft can be changed. To
carry out this operation, loosen the screw, pull the
lever out, and place it in a new position on the shaft.
Tighten the screw once operation is completed.
WARNING
Do not downshift when travelling at a
speed that would force the engine to "over-
rev" or cause the rear wheel to lose grip, if
the immediately lower gear is selected.
CAUTION
Do not shift gears without disengaging the
clutch and closing the throttle. The engine
could be damaged by "over-revving".