Removing And Replacing The Front Control Panel - Renkforce CD-7657 Bedienungsanleitung

Mechanical Installation

Removing and Replacing the Front Control Panel

The front control panel can be removed to prevent theft.
• Before you remove the front control panel, press the
• Press the button (16) to fold down the operating panel.
• Press the operating panel to the left and unhook it from the holder on the right.
• Remove the front control panel and put it into the supplied protective cover.
• For replacing the control panel, place the left side into the holder as illustrated in the figure below (step 1) and
press it slightly to the left.
• Then lock the right side of the operating panel in its holder (step 2).
• Fold up the operating panel again and slightly press the upper right side until it latches.
• Do not press on the display or the buttons.

Make sure to insert the front control panel in the correct way.
Do not press the front against the unit too hard. It can be easily attached by pressing it slightly against
the device at the upper right until it latches.
When you remove the front control panel, please put it into the supplied protective cover.
42

button (1) to turn the product off.
Operating Instructions
English