Removing And Replacing The Front Control Panel; Installation In The Radio Slot - Renkforce sd 7629 Bedienungsanleitung

Removing and replacing the front control panel

The front control panel can be removed to prevent theft.
• Before you remove the front control panel, press the button
• Press the button
• Unlatch the left side.
• Remove the front control panel and put it into the supplied protective cover.
• To attach the front panel, insert the left side into the holder and then snap the right side of the operating panel
into the catch.
• Do not press on the display or the buttons.

Make sure to insert the front control panel in the correct way.
Do not press the front too much against the unit. You can easily put it back by pressing slightly on the
device.
When you remove the front control panel, please put it into the supplied protective cover.
To avoid malfunctioning, you should clean the contacts of the front operating panel and their
counterparts on the device from time to time with a cotton swap soaked with alcohol.

Installation in the radio slot

• Remove the front control panel.
• Carefully remove the plastic frame in the front of the system, by bending it slightly to the outside and pulling it off
from the unit.
1
1
• Unlock the installation frame with the two unlocking keys (fig. 1, no. 1).
• Remove the installation frame towards the back of the system (fig. 1, no. 2).
• Insert the frame into the respective cut-out in the vehicle (fig. 2).
38
(15) and pull the operating panel out of the device on the right side.
2
2
182mm
(1) to turn the product off.
3
53mm
Operating Instructions
English
4