Commissioning/Replacing The Remote Control Battery - Renkforce GI700BR Bedienungsanleitung

Electric Connection
• The constant current terminal +12 V (4) must be connected to a cable that also supplies 12 V permanently when
the ignition is off (terminal 30 of the on-board network). This terminal serves to save the user settings, time, etc.
• The aerial control output (5) supplies a voltage of +12 V with the device on. This cable can be used for the power
supply of an electrical aerial and for the voltage for switching on a car amplifier.
• The ignition terminal +12 V (7) must be connected to a cable that is only live with +12 V when the ignition is on
(terminal 15 of the on-board networks).
Do not connect this terminal to continuous current; otherwise the on-board battery could be discharged when the
vehicle is parked for a longer period of time.
• Connect the ground connection (8) with the vehicle body.

Adhesive techniques, which become ever more common, and painted metal parts impair the electric
conductivity. Therefore, not every metal part is a suitable earthing point.
In most vehicles, the cables for the electric connection and the connection of the speakers have been
laid directly to the slot. If this is not the case, please make sure that any cables placed later are secured
by the respective on-board fuses (see vehicle operation manual).

Commissioning/Replacing the Remote Control Battery

Remove the battery when the device is not in use for extended periods of time.
Leaking or damaged batteries may cause alkali burns if they come in contact with the skin.
Therefore, use suitable protective gloves.
Do not short-circuit the battery and do not throw it into fire. It also must not be recharged.
Danger of explosion.

If required, remove the insulation pad in the battery compartment of the remote control. It protects the
battery from discharge during transport.
• If the remote control no longer functions properly, the battery is discharged and must be replaced with a new one
of the same type.
• Unlock the safety lever and pull the battery holder out at the rear of the remote control.
• Remove the discharged battery and insert a new 3 V-Lithium button cell CR2025. The correct polarity is indicated
in the battery holder.
• Insert the batteries in the remote control again. The safety lever must latch audibly.
56
Operating Instructions

English