EKOM DK50 2V/50 Benutzerhandbuch Seite 8

General safety warnings
The manufacturer designed and manufactured the product to minimise all risks when used
correctly for the intended use. The manufacturer considers it its obligation to lay down the following
general safety precautions.
 Use and operation of the product must comply with all laws and local regulations valid in the
place of use. The operator and user are responsible for following all the appropriate regulations
in the interests of performing work safely.
 Only the use of original parts guarantees the safety of operating personnel and the flawless
operation of the product itself. Only the accessories and parts mentioned in the technical
documentation or expressly approved by the manufacturer should be used.
 The operator must ensure that the device is functioning correctly and safely before every use.
 The user must be familiar with the operation of the device.
 Do not use the product in environments with a risk of explosion.
 The user must inform the supplier immediately if any problem directly related to the operation of
the device occurs.
Safety warnings on protection from electric current
 The device must only be connected to a properly installed, earthed socket.
 Before the product is plugged in, ensure that the mains voltage and frequency stated on the
product are in compliance with the values of the mains.
 Prior to putting the device into operation check for any damage to the connected pneumatic
lines and electrical wiring. Replace damaged pneumatic lines and electrical wirings immediately.
 Immediately disconnect the product from the mains (remove power cord from the socket) in
hazardous situations or in the case of a technical malfunction.
 During all repairs and maintenance, ensure that:
- the mains plug is removed from the power socket
- pressure is vented from the air tank and pipes
 The product shall only be installed by a qualified technician.
NP-DK50 2V 50, 2x2V 110-15_10-2020-MD -6-
DK50 2V/50
DK50 2x2V/110
10/2020