Control Panel - JB-Lighting Varyscan P7 Bedienungsanleitung

P7

5. Control panel

The P7 is equipped with a backlit graphic display, which can be rotated through 180 degree if the
unit is installed upside down.
Rotating the display
Use the centred button to change the orientation of the display. To adjust the personal setting of
the P7 use keys located on the control panel. Functions see menu on page36.
Features and operating of the LCD-Display
The main menu also informs about the DMX-mode. If wireless DMX is used, the field intensity
from the sender will be displayed. Press „ENTER" to enter a menu, select a function or apply a
selection. Press keys „DOWN" and „UP" to scroll within a menu or set values. To escape a func-
tion press key „ESC".
A few functions can be entered or recalled by means of a combination of two keys. For example
FINE ADJUST in the SERVICE area and MODIFY, RUN and REMOTE in the STANDALONE. To
enter these functions press „ENTER", keep it down and press „ESC" in addition. To leave the
menu press the combination in the revers order. Press „ESC" (keep it down) and press „ENTER"
in addition.
The main menu can be locked to avoid an accidental change of the configuration. To lock press
„ENTER" and keep it down and press „ESC" in addition. To unlock press „ESC" (keep it down)
and press „ENTER" in addition.
Special functions are assigned to the display lighting:
The display is not illuminated during reset. Slow flashing of the display illumination means no
DMX signal is connected. Fast flashing of the display illumination showing JB-Lighting means
a failure was reported and stored in the ERROR LIST (To clear - see menu navigation on next
page). Fast flashing of the display illumination showing an error message means an current fail-
ure is reported, e. g. *PAN TIMEOUT - please contact your dealer or our service department. If
the P7 receives a DMX-signal the display illumination dims out after 30 seconds in order not to
irritate during standard operation.
DMX addressing
The P7 can be addressed in the main menu. For addressing in a flightcase, the reset can be
aborted by pressing the right base button during powering the fixture.
- 35 -