Install A Plug On The Power Cord; Control Panel - JB-Lighting Varyscan 7 Bedienungsanleitung

2.5 Installing a plug on the power cord
Install a plug like described in chapter 2.2.
Connected load: Voltage 230Volts, frequence 50Hz, power 1500 VA (7Amps)
Use a power supply of at least 1800VA (8Amps) per unit, as the fixture need more
power during the process of powering up.
Connect the fixture to a propper installed grounded system only. If any doubts
on the electrical installations occur, consult a qualified electrician.
In case of damages occuring due to a not propper installed electrical system,
warranty claims will be invalidated.
Don´t use fixtures when top cover is not fixed propperly. Contact with electronical
parts can result in risk for life. (Electrical shock 5000V)
Connect fixture only after assuring that the electrical installation fits your demands.
If any doubts occur consult a qualified technican!

3. Control panel

To adjust the personal setting of the Varyscan 7 use keys located on the control panel.
Functions see menu on the following page.
To enter the menu press MENU key one time.
Use keys - and + to move within the menu.
Use key ENTER to select the function and to recall the next menu section
To escape press key MENU
JB-lighting Lichtanlagentechnik GmbH Sallersteigweg 15 D-89134 Blaustein Telefon +49 (0)7304-9617-0
23