Control Panel - JB-Lighting Sparx 10 Bedienungsanleitung

1 0
The value of Sparx10 in chain depends on the local power network. Never use more than five in
one line. Power throughput cable must be rated 20A min., have three conductors 1,5mm2 min.
conductor size and a outer cable diameter of 5-15mm. Use only original PowerCon plug from
Neutrik. See installation manual from manufacturer (www.neutrik.com).
Color Function
brown Live
blue Neutral
green/yellow Ground

4. Control panel

The Sparx10 is equiped with a backlit graphic display, which can be rotated through 180 deg. if
the unit is installed upside down.
Rotating the display
Use the centered button to change the orientation of the display. To adjust the personal setting
of the Sparx10 use keys located on the control panel. Functions see menu on the following
page. The Sparx10 can be addressed in the main menu. For addressing in a case, the reset can
be aborted by pressing the right base button during powering the fixture. The main menu also
informs about the DMX-mode. If wireless DMX is used, the field intensity from the sender will
be displayed. Press „ENTER" to enter a menu, select a function or apply a selection. Press keys
„DOWN" and „UP" to scroll within a menu or set values. To escape a function press key „ESC".
A few functions can be entered or recalled by means of a combination of two keys. For example
FINE ADJUST at menu SERVICE and MODIFY, RUN and REMOTE at menu STANDALONE. To
enter these functions press „ENTER", keep it down and press "ESC" in addtion. To leave the
menu press „ESC" hold it down and press „Enter", MODIFY and FINE ADJUST you can leave
only by pressing „ESC".
The main menu can be locked to avoid an accidental change of the configuration. To lock press
"ENTER" and keep it down and press "ESC" in addition. To unlock press „ESC" (keep it down)
and press „ENTER" in addition.
Special functions are assigned to the display lighting:
The display is not illuminated during reset. Slow flashing of the display illumination means no
DMX signal is connected. Fast flashing of the display illumination showing „JB-Lighting" means
a failure was reported and stored in the ERROR LIST (To clear - see menu navigation on next
page). Fast flashing of the display illumination showing an error message means an current failu-
re is reported, e. g. *PAN TIMEOUT - please contact your dealer or our service department. If the
Sparx10 receives a DMX-signal the display illumination dims out after 30 seconds in order not to
irritated during standard operation.
- 36 -
Symbol
„L"
„N"