Power Function; Boil Control Function - Teka IRX 633 Einbau-Anleitung Und Empfehlungen Für Gebrauch Und Instandhaltung

GB
cooking area.
This function is independently available for
each one of the plates.
To activate it, select the plate. The decimal
point will light up. Then push sensor
(13). The symbol "A" will appear in the
indicator and the corresponding pilot (8)
will turn on.
To disconnect this function, all you have to
do is modify the power of the plate or
directly turn it off.
This function supplies "extra" power to the
plate, above the nominal value. Said
power depends on the size of the plate,
(see values specified with * in the presen-
tation section), with the possibility of rea-
ching the maximum value permitted by the
generator.
1 Select the desired plate with the corres-
ponding sensor (3). The decimal point
will light up.
2 On the cursor Slider, push directly on
position
tor will show the symbol P, and the plate
will start to supply extra power.
The Power function has a maximum dura-
tion as specified in table 1. After this time,
the power level will automatically adjust to
9
.
This innovative function is of an enormous
help if you want to cook pasta, rice, eggs,
or boil any kind of food. This function
allows you to perform this cooking method
"almost" automatically.
20
Downloaded from www.Manualslib.com

Power Function

(5). The power level indica-

Boil Control Function

manuals search engine
This function is available only in the plates
where this symbol appears
Pot requirements
For properly using boil control, the pot
must have the following characteristics:
- Bottom size as close as possible to the
diameter of the plate.
- NO COVER.
- Filled more than halfway of its capacity
with room temperature water (never
use lukewarm or hot water).
Not fulfilling these requirements will result
in inadequate control of boiling.
WARNING: do not use this func-
tion for cooking methods other than
boiling water. Never use oil. It can over-
heat and create flames.
Activating the function:
Select the proper plate. The decimal point
lights up.
Push sensor (12). An
the plate indicator and the pilot (9) will turn
on. In the timer for this plate, a moving
segment will appear which indicates that
the system has started to monitor cooking.
When the system detects that it is about to
boil, an initial beep will go off. Take this
time to prepare the food you want to boil or
cook.
After 30 seconds, a second beep will go
off. If you haven't done it already, now is
time to put the food into the pot.
After the second beep, the system will acti-
vate the timer as a chronometer so that
you can control how long the food has
been boiling.
A
will appear on