Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
fig. 4
TURNING THE APPLIANCE ON
The first time the cooktop is plugged in (or
after a power outage), the Block function
will appear as activated (pilot light 10 on).
In this case, you must deactivate the block
function in order to turn the cooktop on. To
do this, push sensor
turns off.
1 Touch sensor
second.
Touch Control is now activated and a
appears in all power indicators (3). If a
cooking zone is hot, the corresponding
indicator will show an
vely.
Once the Control is on, you must activate
a plate within 10 seconds, otherwise the
Touch Control will automatically turn off.
While the touch control is activated, it can
be disconnected at any moment by tou-
ching the general on/off sensor
even if it has been blocked (see section
"Blocking cooktop sensors"). Sensor
(1) always has priority in disconnecting the
touch control.
18
Downloaded from
www.Manualslib.com
(6) until pilot (10)
(1) for at least one
H
0
and a
manuals search engine
ACTIVATING PLATES
Once the Touch Control is activated with
sensor
by following these steps:
1 Select the plate by using the correspon-
ding sensor (3). In other words, press
with your finger the NUMBER INDICA-
TOR. If the glass is hot, the said indica-
tor will go from showing an H to showing
level 0. The decimal point to the bottom
right of the number lights up, indicating
0
that the plate has been selected.
2 Use the cursor slider (2) to choose a
alternati-
cooking level between
As long as the plate is selected, in other
words, with the decimal point lit up, its
power level can be modified.
TURNING A PLATE OFF
A plate can be turned off by decreasing its
(1)
cooking level to
plate must have been previously selected
(decimal point lit up).
Once a plate has been turned off, an
appear on the corresponding power indi-
(1), any plate can be turned on
0
9
and
0
. In order to do this, the
.
H
will
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
