Power Function - Teka IBC 64000 TTC Montageanleitung Und Empfehlungen Zur Verendung Und Wartung

EN
For a fast powering up at maximum
power: with the plate at 0, touch the
sensor (3) once. The plate will
directly activate at level 9.
By continuing to press down on any
of these two sensors
they will repeat the action every half
a second, without needing to press
consecutively.
TURNING OFF A PLATE
With the sensor (3), lower the power
to level 0.
The hotplate will automatically power
off.
For a fast power down: no matter what
the power level, by simultaneously
pressing the sensors (3) and
the plate will immediately power off.
When a hot plate is switched off an
H will appear in its power indicator
(3), if the glass surface of the related
cooking area is hot and there is a risk
of burns. When the temperature drops,
the indicator (5) switches off (if the hob
is disconnected), or otherwise a "-" will
light up if the hob is still connected.
TURNING ALL PLATES OFF
All plates can be simultaneously
disconnected by using the general on/
off sensor (1). All plate indicators (3)
will turn off. If the heating zone turned
off is hot, its indicator shows an H.
20
Induction cooking zones have a built-in
pan detector. This way, the plate will
stop working if there is no pan present
or if the pan is not suitable.
(3) or (4),
The power indicator (5) will show a
symbol to designate "there is no pan
" if, while the zone is on, no pan is
detected or the pan is not suitable
If a pan is taken off the zone while it
is running, the plate will automatically
stop supplying energy and it will
show the symbol for "there is no pan".
When a pan is once again placed
on the cooking zone, energy supply
will resume at the same power level
previously selected.
(4),
If a pan is taken off the zone while it
is running, the plate will automatically
stop supplying energy and it will
show the symbol for "there is no pan".
When a pan is once again placed
on the cooking zone, energy supply
will resume at the same power level
previously selected.
When finished, turn off the
cooking zone by using the touch
controls. Otherwise an undesired
operation could occur if a pan is
accidentally placed on the cooking
zone during the three minutes.
Avoid possible accidents!
Pan detector Silencer of the beep
With the cooktop in off state, press
together the sensors
during 3 seconds.
After 3 seconds. It will be shown the
current status of the buzzer (
"on" if it´s enabled,
disabled). With the sensors
(10) , it can be changed the status.
To confirm the selection press the
(8).
The deactivation will not be applied
to all the function, as for example the
beep for on/off.
The deactivation will not be applied to
all the functions, as for example the
beep for on/off.

Power Function

This function supplies "extra" power
to the plate, above the nominal value.
Said power depends on the size of the
plate, with the possibility of reaching
the maximum value permitted by the
generator.
1 Activate the plate corresponding to
power level 9.
2 From the power level 9, press the
sensor (4), and the symbol
Fig.2
(7) y (8),
"off" if it´s
(9) and