Power Surges In The Network; Suggestions And Recommendations; Cleaning And Care - Teka IRX 633 Einbau-Anleitung Und Empfehlungen Für Gebrauch Und Instandhaltung

Power surges in the network

The touch control can bear cer-
tain variations in voltage supply admis-
sible by electric distribution networks.
Abnormally high power surges can
cause the control system to break
down (just like with any other electric
device).
Suggestions and
recommendations
To get the best use out of your hob, you
should follow the following suggestions
and recommendations:
* Utilize receptacles with completely flat
bottoms, given that the larger the con-
tact surface is between the glass and
the receptacle, so much the better will
the plate performance be. In order to
prevent denting the bases of the cook-
ware, recommend using cookware with
thick bases. Figure 5 shows how cook-
ware that is dented or concave has a
smaller contact surface.
fig. 5
Right
* Make sure that cookware is well-centred
on the drawings that indicate the heating
zone.
* Dry the bases of cookware before pla-
cing them on the hob.
* Do not leave any plastic object or utensil
or any aluminium foil lying on the vitro-
ceramic hob.
Downloaded from www.Manualslib.com
Wrong Wrong
manuals search engine
* Do not drag over the glass cookware with
corners or edges that could damage the
glass.
* The glass will withstand bangs from large
cookware that does not have sharp
edges. Please be careful with impacts
from small, sharp utensils.
* Please be careful not to let sugar or pro-
ducts containing sugar fall on the glass,
since they may react with the glass
when the glass is hot and damage the
surface.
If you cannot turn off the heating
element due to an overflow of creams,
soups or similar foods, use a wet rag to
remove the food from the touch control
panel and keep the rag on the on/off
sensor button so that the touch control
panel turns off.

Cleaning and care

To maintain the vitroceramic hob in good
condition, it should be cleaned with suitable
products and instruments. The vitroceramic
hob should be cleaned each time it is used,
when it is either lukewarm or cool. This
makes cleaning easier and prevents dirt from
accumulating through repeated use.
Never use aggressive cleaning products or
products that can scratch the surfaces (the
table below shows various common pro-
ducts that may be used). The hob should
also not be cleaned using steam-based
appliances.
CLEANING AND CARING FOR THE
GLASS
The degree of soiling should be taken into
account when cleaning the glass, and the
instruments and products used should vary
depending on how dirty it is.
GB
23