Troubleshooting; Product Does Not Move; Product Does Not Achieve The Cycle Times; Product Gets Too Hot - SCHUNK LDM Serie Montage- Und Betriebsanleitung

Troubleshooting

8.1 Product does not move

Possible cause
Electrical connection incorrect e.g. Phase
rotator.
Error in the drive controller.

8.2 Product does not achieve the cycle times

Possible cause
Attachments on the product have too much
mass.
Specifications made by control unit are not
correct.
Error in the drive controller.

8.3 Product gets too hot

Possible cause
Temperature sensor not connected
properly.
Attachments on the product have too much
mass.
Error in the drive controller.
126 06.00 | LDM | Assembly and Operating Manual | en | GAS360926
8 Troubleshooting
Corrective action
Electrical connection according
specifications e.g. carry out circuit diagram.
See documentation for drive controller.
Corrective action
Check cycle time calculation.
Correct specifications.
See documentation for drive controller.
Corrective action
Check electrical connection.
Check cycle time calculation.
See documentation for drive controller.