Ambient Conditions And Operating Conditions; Personnel Qualification - SCHUNK LDM Serie Montage- Und Betriebsanleitung

2.5 Ambient conditions and operating conditions

2.6 Personnel qualification

Trained electrician
Qualified personnel
Instructed person
Service personnel of
the manufacturer
Make sure that the product, its mounting elements and the flange-
mounted parts are a sufficient size for the application.
Make sure that the environment is clean and the ambient
temperature corresponds to the specifications given in the catalog.
Observe the maintenance and lubrication intervals.
Make sure that the environment is free from splash water and
vapors as well as from abrasion or processing dust.
The product must be operated with drive control units. We
recommend using the control units offered by SCHUNK. Please
consult SCHUNK if you intend to use control units of other
manufacturers.
Protect the product from strong sunlight or heat.
Protect the product from chips or dust, abrasive media, vibration,
shock and moisture in order to prevent contamination.
Inadequate qualifications of the personnel
If the personnel working with the product is not sufficiently
qualified, the result may be serious injuries and significant
property damage.
• All work may only be performed by qualified personnel.
• Before working with the product, the personnel must have read
and understood the complete assembly and operating manual.
• Observe the national safety regulations and rules and general
safety instructions.
The following personal qualifications are necessary for the various
activities related to the product:
Due to their technical training, knowledge and experience, trained
electricians are able to work on electrical systems, recognize and
avoid possible dangers and know the relevant standards and
regulations.
Due to its technical training, knowledge and experience, qualified
personnel is able to perform the delegated tasks, recognize and
avoid possible dangers and knows the relevant standards and
regulations.
Instructed persons were instructed by the operator about the
delegated tasks and possible dangers due to improper behaviour.
Due to its technical training, knowledge and experience, service
personnel of the manufacturer is able to perform the delegated
tasks and to recognize and avoid possible dangers.
06.00 | LDM | Assembly and Operating Manual | en | GAS360926
Basic safety notes
81