Translation Of Original Declaration Of Incorporation - SCHUNK LDM Serie Montage- Und Betriebsanleitung

Translation of original declaration of incorporation

10 Translation of original declaration of incorporation
in terms of the Directive 2006/42/EG, Annex II, Part 1.B of the European Parliament and of
the Council on machinery.
Manufacturer/
Distributor
We hereby declare that on the date of the declaration the following partly completed
machine complied with all basic safety and health regulations found in the directive
2006/42/EC of the European Parliament and of the Council on machinery. The declaration
is rendered invalid if modifications are made to the product.
Product designation:
The partly completed machine may not be put into operation until conformity of the
machine into which the partly completed machine is to be installed with the provisions of
the Machinery Directive (2006/42/EC) is confirmed.
Applied harmonized standards, especially:
EN ISO 12100:2010
EN 60204-1: 2006
EN 61000-6-2 (2005)
IEC 61800-3: 2009-10
The manufacturer agrees to forward on demand the relevant technical documentation for
the partly completed machinery in electronic form to national authorities.
The relevant technical documentation according to Annex VII, Part B, belonging to the
partly completed machinery, has been created.
Person authorized to compile the technical documentation:
Markus Ganter, Address: see manufacturer's address
St. Georgen, September 2020
136 06.00 | LDM | Assembly and Operating Manual | en | GAS360926
SCHUNK Electronic Solutions GmbH
Am Tannwald 17
D-78112 St. Georgen
Linear motor shaft / LDM / electric
Safety of machinery - General principles for design -
Risk assessment and risk reduction
Safety of machinery – Electrical equipment of machines, Part 1:
General requirements
Electromagnetic compatibility (EMC) - Partl 6-2: Generic
standards -Immunity for industrial environments
IEC 61000-6-2: 2005
Adjustable speed electrical power drive systems - Part 3:
EMC requirements including special test procedures
p.p. Matthias Heilmann;
Head of Development