Changing The Wipers - SCHUNK LDM Serie Montage- Und Betriebsanleitung

10. Slide the covering tape (6) underneath the guided slide (1) and
place it on the magnetic strip (4).
11. Slightly lift up one side of the covering tape (6) and use forceps
to remove the protective film (5) from the adhesive film.
12. Press the covering tape (6) onto the magnetic strip (3) while
pulling off the protective film.
13. Unscrew the 2 magnetic strip clamps (2).

7.10 Changing the wipers

Changing the wipers
1 guided slide
CAUTION
When using wipers, it is especially important that you clean
•
the guide strips and lubricate them with an oil-soaked cloth.
Note that the usable stroke is reduced when installing wipers.
•
1. Slide the guided slide (1) to the center of the axis.
2. Release the mounting screw (2).
3. Change the wiper (3).
4. Tighten the mounting screw (2).
06.00 | LDM | Assembly and Operating Manual | en | GAS360926
Maintenance and repair work
2 mounting screw 3 wiper
121