Guided Slide - Changing The Support Rollers On The Eccentric Side - SCHUNK LDM Serie Montage- Und Betriebsanleitung

7.6 Guided slide – Changing the support rollers on the eccentric
Uninstalling the
support rollers
Installing the support
rollers
side
Support roller change on eccentric side
1. Remove the 2 roller covers (1).
2. Unscrew the 8 pressure pins (2).
3. Pull out the 4 eccentric shafts (3) using the extracting tool (4).
4. Remove the 4 support rollers (5).
1. Fit the 5 support rollers (4).
2. Turn to fit the 4 eccentric shafts (3) into place.
3. Turn the eccentric shaft (3) using a hexagon socket wrench
until you can no longer turn the support roller (5) by hand.
4. Check the initial tension
rollers on the locating bearing side
5. Screw in the 8 new pressure pins (2) – tightening torque of 2 Nm.
6. Fit the 2 roller covers (1).
06.00 | LDM | Assembly and Operating Manual | en | GAS360926
Maintenance and repair work
Guided slide – Changing the support
[ 118]
}
117