Programmable Interface Module (Pim) Status Menu - Kohler 14/20RESA Betriebsanleitung

3.19 Programmable Interface
Module (PIM) Status Menu
The PIM status menu displays the status of inputs and
outputs connected to the programmable interface
module (PIM). this menu appears only if a PIM is
connected. This is a status display menu only. Input
and output settings cannot be changed from the RDC2
controller's user interface.
PIM
Status:
Figure 3-24 Programmable Interface Module (PIM) Status Menu
52 Section 3 RDC2 Controller Operation
PIM 1 ---->
<---- Return
A personal computer running Kohler SiteTecht
software is required to change the input and output
settings. Contact an authorized distributor or dealer for
service.
The Kohlerr OnCuer Plus Management System can be
used to turn outputs on and off. See the OnCue Plus
Operation Manual for instructions.
Input 1
In/Active
Input 2
In/Active
Output 1:
In/Active
Output 2:
In/Active
Output 3:
In/Active
Output 4:
In/Active
Output 5:
In/Active
Output 6:
In/Active
<---- Return
tp6810
TP-6804 1/15