Generator Set Information Menu; Genset Run Time Menu - Kohler 14/20RESA Betriebsanleitung

3.12 Generator Set Information
Menu
The generator set model number and serial numbers
are displayed. No changes are allowed from this menu.
Model and serial numbers are factory set and should not
require changes in the field, except in the event that the
controller is being replaced.
running Kohler SiteTech software is required to enter
the generator set model number and serial numbers on
a replacement controller. Contact an authorized Kohler
distributor/dealer for service.
Genset ---->
Information
Figure 3-13 Generator Set Information Menu
42 Section 3 RDC2 Controller Operation
A personal computer
Genset M/N:
20RESA
Genset S/N:
########
Controller S/N:
########
<---- Return
tp6804

3.13 Genset Run Time Menu

The data shown in Figure 3-14 are displayed.
changes are allowed from this menu.
Eng Runtime displays the total number of hours that the
generator set engine has run.
resettable.
The Next Maintenance menu shows the number of
hours of generator set operation until maintenance is
required. The estimated date for the next scheduled
maintenance is also displayed.
reminder intervals are
manufacturer's recommendation for changing the oil.
Refer to Section 5, Scheduled Maintenance, for
maintenance instructions.
After changing the
recommended maintenance, go to the Overview menu
to reset the maintenance timer. See Section 5.2.5 for
instructions to reset the maintenance timer.
Genset ---->
Run Time
Note: Sample data shown.
Figure 3-14 Generator Set Run Time Menu
The runtime is not
The maintenance
based on the engine
oil and performing
Eng Runtime:
24.5 h
Eng Starts:
18
Next Maintenance:
150 h or Mar2014
<---- Return
TP-6804 1/15
No
other
tp6810