Kohler 14/20RESA Betriebsanleitung Seite 19

Programmable Interface Module (PIM) status
D
displays
Input status (active/inactive)
d
Output status (active/inactive)
d
Load control module (LCM) menus
D
Load status
d
Test function
d
DC2 Controller Features
Four-button keypad:
D
EXERCISE pushbuttons
LED indicators for OFF, AUTO, and RUN modes
D
LCD display:
D
Two lines x 16 characters per line
d
Backlit display with adjustable contrast for
d
excellent visibility
Scrolling system status display
D
Generator set status
d
Voltage and frequency
d
Engine temperature
d
Oil pressure
d
Battery voltage
d
Engine runtime hours
d
Maintenance reminders
d
OnCuer status (connected/disconnected)
d
Date and time displays
D
TP-6804 1/15
OFF, AUTO, RUN, and
Smart engine cooldown senses engine temperature
D
Digital isochronous
D
steady-state speed at all loads
Digital voltage regulation: ±0.5% RMS no-load to
D
full-load
Automatic start with programmed cranking cycle
D
Exercise modes
D
Unloaded weekly exercise with complete system
d
diagnostics
Unloaded full-speed exercise
d
Loaded full-speed exercise (Model RXT ATS
d
required)
Front-access mini USB connector for SiteTecht
D
connection
Integral Ethernet connector for Kohlerr OnCuer Plus
D
Built-in 2.5 amp battery charger
D
Remote two-wire start/stop capability for optional
D
connection of Model RDT or RSB transfer switches
Diagnostic messages
D
Displays diagnostic messages for the engine,
d
generator set, model RXT transfer switch, and
optional programmable interface module (PIM)
and load control module (LCM)
Over 70 diagnostic messages can be displayed
d
A laptop computer and Kohlerr SiteTech software
D
can be used to change system settings or upgrade
controller firmware.
Section 1 Descriptions and Service Views
governor to maintain
17