Herunterladen Diese Seite drucken

Adjusting The Shoulder Belts; Regolazione Delle Cinghie Per Le Spalle - CYBEX Aton Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Aton:

Werbung

ADjUSTING THE SHOULDER BELTS

Note! Only if the shoulder belts
optimum security can be provided.
• when the baby is approximately 3 months the seat
insert can be removed to provide enough space for
the child (see page 29).
• The height of the shoulder belts
in such a way that they run through the belt slots
directly above the baby's shoulders.
To adjust the height of the shoulder belts
the next steps:
• Press the red button to open the buckle e.
• Pull the shoulder pads
remove them.
• First pull one buckle tongue
out of the belt slot s. now insert it again through the
next higher slot. Repeat this step to the adjust the
other side as well.
Note! Please make sure that the shoulder belts
not twisted but should lie flat against the main seat, run
evenly through the belt slots
e.
c
are adjusted correctly
c
must be adjusted
c
please follow
d
over the belt tongues
t
through the cover and
c
s
and down to the buckle

REGOLAZIONE DELLE CINGHIE PER LE SPALLE

Nota Bene!
la sicurezza ottimale si ottiene soltanto
se le cinghie per le spalle
corretto.
• Al raggiungimento dei tre mesi circa del bambino,
il riduttore potrà essere rimosso per garantire più
spazio (vedi pagg. 29)
s
• l'altezza delle cinghie per le spalle
regolata in modo che esse scorrano attraverso le
s
fessure
direttamente al di sopra delle spalle del
bambino.
Per regolare l'altezza delle cinghie per le spalle
t
to
seguite il procedimento di seguito descritto:
• Premere il pulsante rosso per aprire la fibbia e.
• Sfilare i cuscinetti copricinghie
sugli agganci t.
• Sfilare l'aggancio
quindi attraverso la fessura s. Reinserirlo quindi
are
attraverso la fessura superiore. Ripetere l'operazione
da ambo i lati.
Nota Bene!
Verificare che le cinghie per le spalle
c
siano perfettamente piatte contro il sedile e non
attorcigliate, che scorrano uniformemente attraverso
le apposite fessure
c
sono regolate in modo
c
dovrà essere
d
facendoli scorrere
t
attraverso il rivestimento e
s
fino alla fibbia e.
c
15

Werbung

loading