Output Configuration - OSRAM e:cue SYMPL bridge Node Bedienungsanleitung

Output configuration

i
You can change the login password to the
SYMPL bridge Node's configuration page and its device
name at "Settings" page. Do not forget the new password.
i
The SYMPL bridge Node should be only accessed from one
browser tab at a time.
In case there is no response please wait a while or reopen
the browser to end pending connections.
i Please note that after changing the IP address, the device
currently will lose its connection and needs to be
reconnected under the new IP address.
6 Output configuration
Access the web interface to first configure the data output of each port and
to secondly map the data input of two sources. Then define a third source
that determines the switching between the two input sources. Alternatively
you can switch between the input sources manually over the web interface.
For each of the eight ports, the data output is composed of up to 4 parts of
data from up to 4 input universes:
Source 1
Universe a
Universe b
Universe c
Universe d
To access the web interface, open a common web browser on a connected
22
take (len1) channels
starting at offset1
take (len2) channels
starting at offset2
take (len3) channels
starting at offset3
take (len4) channels
starting at offset4
Port x
e:pix output for Source 1
Part 1 Part 2
(len1) (len2)
Part 3 Part 4
(len3) (len4)