Configuration; Lce 3 (Fx) Operation - OSRAM e:cue Lighting Control Engine 3 Bedienungsanleitung

Configuration

When adding or removing devices to or from the
system, ensure that the power cables for the devices
!
are unplugged before the signal cables are
connected.
6 Configuration
The LCE 3 (fx) runs on Microsoft® Windows 10™ as operating
system. It enables you to run lighting control applications as
e:cue's SYMPHOLIGHT and e:cue's Lighting Application Suite
(LAS) on the LCE 3 (fx). When first powering the LCE 3 (fx), a setup
of the server is required. Set the network properties for the
LCE 3 (fx) and the lighting control applications afterwards.
6.1

LCE 3 (fx) Operation

Connect a display and input devices (keyboard, mouse) to the
Lighting Control Engine 3 (fx). Display and input devices are
always necessary when accessing any application or settings on
the LCE 3 (fx). Connect the power supply and switch on the
LCE 3 (fx) with the power button. The LED power indicator lights
up in white while the LCE 3 (fx) accesses the hard drive.
You can hot swap devices to the USB interfaces, the Mini
DisplayPort ouputs, to the mainboard interfaces, and the Video
Capture Card of the LCE 3 (fx).
i
Do not switch off the server with the power button or
by removing the power supply, but use the Windows
shutdown function to prevent loss of data.
30