Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
4.1
Installation conditions
Installation position
Horizontal spacing
Minimum vertical rail grid spacing
Recommended vertical rail grid spacing
4.2
Mounting process
The SYMPL bridge Node is designed to mount onto a 35mm DIN rail
(EN 60715) in a horizontal position.
1
2
You can also mount the device on any flat surface. Use a 3 to 3.5mm screw
for the hanger hole.
For mechanical stability, mounting on a rail is recommended.
4.3
Ethernet connection
The pin-assignment of the Ethernet port corresponds to RJ45 standards.
You can use every common Ethernet component, like cable, splitters, and
switches. Connect the SYMPL bridge Node at the designated Ethernet
interface with a patch cable (RJ45, CAT5).
Ground the Ethernet cable for outdoor installations (optional
!
for indoor only).
16
Terminals on top and bottom
On both sides 18 mm
115 mm (90 + 25 mm)
(excluding conduit)
160 mm (with 40 mm conduit)
1. Clip the device to the rail from
top.
2. Apply gentle pressure to the
top front to snap it in place. The
device has been mounted
successfully.
Werbung
Inhaltsverzeichnis
