Test Mode Via Web Interface - OSRAM e:cue SYMPL bridge Node Bedienungsanleitung

Test mode
of 96 channels (pattern 2).
• Short-press the Test button to switch all channels to 100%
(pattern 3).
• Short-press the Test button to switch all channels off (pattern 4).
• Short-press the Test button to alternate between the individual
DMX ports and the four test patterns. After the individual test of the
DMX port 8, all DMX ports are tested simultaneously. Another short-
press starts the test patterns from the beginning.
• To exit the Test mode at any time, keep the Test button pressed for
5 seconds. The device proceeds to normal operation. The DMX LEDs
no longer flicker and the Test / Error LED is off.
For the SYMPL bridge Node, press the Identify button to switch between
DMX and e:pix testing output.
7.2

Test mode via web interface

The web interface of the SYMPL bridge Node provides four different test
patterns and allows to change their properties.
To access the web interface, open a common web browser on a connected
PC. Enter the SYMPL bridge Node's IP address into the address bar:
e.g. http://192.168.123.1.
28