Test Mode; Test Mode Via Test Button - OSRAM e:cue SYMPL bridge Node Bedienungsanleitung

Source 1 and Source 2. For sACN you can chose between Multicast
and Unicast transmission by selecting the "Multicast" checkbox.
3. Click the "submit" button to save the configuration.
For manual source switching, you can click on the buttons at the end of the
page. Please note that if the source is configured properly, the manual
switching command will be overwritten by any incoming source value. To
prevent overwriting, either set the "Channel" to 0 or select "none" as
protocol type.
7

Test mode

- SYMPHOLIGHT v5.0 or higher needed-
The SYMPL bridge Node provides a Test mode for the connected DMX
devices. The Test mode is designed for DMX luminaires. There are two
kinds: using the Test button and using the web interface of the
SYMPL bridge Node.
Please note that the Test mode overwrites all other DMX output like running
shows for the time of testing. A running show is reverted to after exiting the
Test mode.
The Test mode is indicated by flickering DMX LED(s) and the blinking
Test / Error LED.
7.1

Test mode via Test button

The Test button allows to test the connected DMX devices directly with the
SYMPL bridge Node.
• Keep the Test button pressed for about 5 seconds until the DMX 1
LED flickers and the Test / Error LED flashes in the short-short-long
sequence. Releasing the button now starts the Test mode at the first
DMX port with blinking lights of all channels (test pattern 1).
• Short-press the Test button to switch to chasing lights at intervals
Test mode
27