Balluff BIS U-6026-034-104-06-ST35 Betriebsanleitung Seite 67

BIS U-6026-034-1_4-06-ST35
Processor unit
7
Setting the processor unit parameters (continued)
If the device is able to establish the last known connection,
BIS connected...appears in the status bar.
If the device is not able to establish a connection, BIS not
connected... appears in the status bar.
The device must then be connected manually:
4. Click P S and i
rogram ettingS
⇒ The Interface Settings window opens.
Interface settings for service interface (RS232)
When the program is started the device automatically
connects if Connect on startup is selected in the Interface
Settings window (factory setting).
When the Interface Settings window is opened, the last
known connection is displayed and the bar above the
S button turns yellow.
earch
1. Click on S .
earch
⇒ The program searches for connections.
If the program finds a connection, the connection settings
are displayed and the bar above the S
green.
2. Click on c
.
onnect
⇒ The device is connected.
If the program does not find a connection, the bar above
the S button turns red.
earch
www.balluff.com
in the menu bar.
nterface
button turns
earch
Device settings
Carrier follow-up time
For hardware version 2.0 or higher, the Carrier
follow-up time function no longer exists. The
value does not have any effect.
Follow-up time in seconds of the switched-on antennas
after the command is sent. The read or write command
should be executed within this time after detection.
Factory setting: 5 seconds
Max. number of tags at the same time
Maximum number of expected data carriers in the field.
Factory setting: 128
Ambient
Factor rereadings (only for asynchronous detection or
dynamic mode)
Number of rereadings after which a data carrier is reported
as present (tag coming) or number of failed rereadings
after which a data carrier is reported as not present (tag
going) (only in dynamic mode).
Factory setting: 5
english 19