Kessel NS 2 Anleitung Für Einbau, Bedienung Und Wartung Seite 93

The switch-on time can be set as follows in the respective menu item of the system components stated above:
• Press the OK key, and the switch-on time of the system component can then be set (max. 99:59 min.). The
V\VWHP FRPSRQHQW LV DXWRPDWLFDOO\ VZLWFKHG RQ ZKHQ WKH ÀQDO GLJLW RI WKH VZLWFKRQ WLPH LV FRQÀUPHG 7KH
remaining period of time must be read out.
Testing the heating cover
• Make sure that the wastewater temperature in the grease separator is below the set maximum temperature* .
• Activate manual operation and, using the
will then begin.
The function of the heating cover is guaranteed if no error message is output during this period of 20 min.
* Factory setting 50° C
Testing the mixer motor
The mixer motor may be put into operation only when the heating cover is at operating temperature (factory set-
ting 50°C). The mixer unit may be damaged if there are hardened (cold) grease deposits in the heating cover.
• Activate manual operation and, using the
• 0DNH VXUH WKDW WKH PL[HU PRWRU UXQV WR GR VR &DUU\ RXW D YLVXDO FKHFN WKURXJK WKH FXWRXW LQ WKH PRWRU ÁDQJH
it is possible to observe the drive shaft.
2016/05
Assembly
Heating cover menu item, set the switch-on time to 20 min. Heating
Mixer motor menu item, set the switch-on time to 05:00 (min.).
57 / 80