Cleaning The Grease Separator - Kessel NS 2 Anleitung Für Einbau, Bedienung Und Wartung

7.3

Cleaning the grease separator

• Carry out the tasks that are described under 4.3 Disposal (discharging the sludge trap and the grease
separator).
• Make sure that no more wastewater can be supplied.
• Disconnect the power supply.
• Remove the maintenance cover from the sludge trap <23>.
• Remove the maintenance cover from the Ballance tower <30>.
• Discharge the grease separator; to do so, extract the wastewater from the Ballance tower <31>
• Remove the heating cover ventilation <36>.
16
• Disconnect the heating cover power supply <41>.
• Open the grease separator clamping ring <49> and remove the heat-
ing cover<42>.
• Remove any grease residue mechanically from the heating cover
from the inside (e.g. with a wooden or plastic spatula, no metal).
Do not clean the grease separator with a water pressure
higher than 5 bar and a water temperature higher than 50°C.
Do not apply a high-pressure cleaner to the seals. If soap
has been used for cleaning purposes, rinse out/extract the
residue as it could lead to malfunctions.
Maintenance
36 30
35
ÀJ 
72 / 80
16
ÀJ 
41
23
30
35
31
42
49
ÀJ 
2016/05