Inserting/Removing The Battery; Checking The Battery Charge Level; Recharging The Battery - Parkside PLGK 12 A2 Originalbetriebsanleitung

GB IE
• Charge the battery before using
it for the first time.
• Only use chargers from the
Parkside X 12 V Team series to
recharge the battery.
• If the operating time is con-
siderably shortened despite
charging, this shows that the
rechargeable battery is depleted
and must be replaced. Only use
an original replacement battery
from the Parkside X 12 V Team
series, which can be purchased
from the online shop (see the
"Spare parts" section).
• Always comply with the latest
safety information, as well as
the regulations and information
relating to environmental protec-
tion.
• Defects resulting from improper
handling are not covered by the
guarantee.
Inserting/removing the
battery
1. To remove the battery (1) from
the device, press both release
buttons (2) on the battery and
pull the battery out.
2. To insert the battery (1), push
the battery along the guide rail
into the device. You will hear it
click into place.
Only insert the rechar-
geable battery once
the battery-operated
tool is ready for use.
22
Checking the battery
charge level
The battery's (1) charge level is indi-
cated by the charge state indicator.
• The charge level of the battery is
indicated by illumination of the
corresponding LED lights while
the device is in operation. Press
and hold the power button to
view.
red-yellow-green => Battery fully
charged
red and yellow => Battery half
charged
red => Battery needs
to be charged

Recharging the battery

If warm, allow the battery
to cool before charging.
Charge the battery (1)
when only the red LED on
the level indicator is illumi-
nated.
The battery's (1) charge
level is indicated by the
charge state indicator.
The charging time is around
1 hour (PAPK 12 A2).
1. Remove the battery (1) from the
appliance if necessary.
2. Plug the battery charger (3) into
a mains outlet.