Inserting/Removing The Battery; Checking The Battery Charge Level; Recharging The Battery - Parkside PLGK 12 V A2 Originalbetriebsanleitung

• Charge the battery before
using it for the first time.
• Only use chargers from the
Parkside X 12 V Team series
to recharge the battery.
• If the operating time is con-
siderably shortened despite
charging, this shows that
the rechargeable battery is
depleted and must be re-
placed. Only use an original
replacement battery from the
Parkside X 12 V Team series,
which can be purchased from
customer service.
• Always comply with the
latest safety information, as
well as the regulations and
information relating to envir-
onmental protection.
• Defects resulting from im-
proper handling are not
covered by the guarantee.
Inserting/removing the
battery
1. To remove the battery (1) from
the device, press both release
buttons (2) on the battery and
pull the battery out.
2. To insert the battery (1), push
the battery along the guide
rail into the device. You will
hear it click into place.
Only insert the re-
chargeable battery
once the battery-op-
erated tool is ready
for use.
Checking the battery
charge level
The battery's (1) charge level is
indicated by the charge state
indicator.
• The charge level of the bat-
tery is indicated by illumin-
ation of the corresponding
LED lights while the device is
in operation. Press and hold
the power button to view.
red-yellow-green =>
Battery fully charged
red and yellow =>
Battery half charged
red =>
Battery needs to be charged

Recharging the battery

Allow a hot battery to
cool before charging.
Charge the battery (1)
when only the red LED
on the level indicator is
illuminated.
GB IE
29