Herunterladen Inhalt Inhalt Diese Seite drucken

Before Use; Mounting; Assembling The Welding Mask; Welding With Flux-Cored Wire - Parkside PSGS 120 A1 Bedienungs- Und Sicherheitshinweise

4-in-1-kompaktschweissgerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
Safety instructions / Before use / Mounting / Welding with flux-cored wire
– electronic and electrical safety
equipment
– people with cardiac pacemak-
ers or hearing aids
– measurement and calibration
devices
– interference immunity of other
equipment nearby
– the time at which the welding
work is carried out.
The following is recommended
to reduce possible interference
radiation:
– equip the mains connection
with a mains filter
– the 4-in-1 compact welder must
be regularly maintained and
kept in a good condition
– welding cables should be
completely uncoiled and run as
close to parallel with the floor
as possible
– devices and systems that are
compromised by the inter-
ference radiation must be
removed from the welding area
or shielded.
46
GB/IE
z Before use
Take all parts from the packaging
and check whether the 4-in-1
compact welder or parts show any
damage. If this is the case, do not
use the 4-in-1 compact welder.
Contact the manufacturer via the
indicated service address.
Remove all protective films and other
transport packaging.
Check that the delivery is complete.
z Mounting
z Assembling the welding
mask
Insert the dark welding lens
the writing facing up into the shield
body
(see Figure C). To do this,
20
if necessary, press gently from the
front against the disc, until it clicks
into place The labelling on the dark
welding lens
21
from the front of the protective shield.
Push the handle
into the corresponding notch of the
mask, until it snaps into place
(see Figure C).
z Welding with flux-cored
wire
Always unplug the mains
plug from the mains socket prior to each
maintenance task or preparatory work
in order to prevent the risk of an electric
shock, injury or damage.
Different welding wires will be
Note:
needed depending on the application.
Welding wires with a diameter of
0.6 – 0.8 mm can be used with this
device.
with
21
must now be visible
from the inside
22

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 332971_1907

Inhaltsverzeichnis