Residual Risk; Package Contents; Parts Description - Parkside PSGS 120 A1 Bedienungs- Und Sicherheitshinweise

Introduction
else. Any use that differs to the intended
use as stated above is prohibited and
potentially dangerous. Damage or
injury caused by misuse or disregarding
the above warning is not covered by
the warranty or any liability on the part
of the manufacturer. The device has
been designed for household use only
and must not be used in commercial or
industrial applications. Commercial use
will void the guarantee. Observing the
safety instructions and assembly instruc-
tions and operating information in the
instructions for use is also a component
of the intended use.
It is imperative to adhere to the applica-
ble accident prevention regulations.
The device must not be used:
in insufficiently ventilated rooms,
„
in explosive environments,
„
to defrost pipes,
„
in the vicinity of people with cardiac
„
pacemakers and
in close proximity to easily
„
flammable materials.

Residual risk

Even if you operate the device as
intended, there will be residual risks.
The following dangers may occur in
connection with the build and design
of this 4-in-1 compact welder:
Eye injuries due to glare,
„
Touching hot parts of the device or
„
workpiece (burn injury),
In case of improper protection risk of
„
accident and fire through sparks and
slag particles,
Harmful emissions from smoke and
„
gases if there is a lack of air or
if closed rooms are insufficiently
extracted.
Reduce the residual risk by carefully
using the device as intended and
observing all instruction.
36 GB/IE
z Package contents
1 4-in-1 Compact welder 120
2 Welding nozzles for steel wire
(1x 0.8 mm; 1x 0.6 mm)
1 Chipping hammer with wire brush
1 Welding mask
1 Operating instructions
1 Earth terminal with cable
1 MIG torch with welding cable
1 Flux-cored welding wire spool
450 g for inert gas welding
1 Argon gas cylinder 0.95 l
1 Pressure regulator
z Parts description
Cover wire feed unit
1
Handle
2
Control dial for wire feed
3
Control dial for setting the welding
4
current
Mains plug
5
Earth cable with earth terminal
6
Torch
7
Torch button
8
Plug
9
Welding mode selector switch
10
Overload protection control lamp
11
Main switch ON/OFF
12
(incl. power indicator lamp)
Inert gas--inlet tubing
13
Pressure regulator
14
Welding nozzle (0.6 mm)
15
Welding nozzle (0.8 mm)
16
Flux-cored welding wire spool (steel)
17
Ø 0.8 mm / 450 g
Chipping hammer with wire brush
18
Feed roll
19
Shield body
20
Dark welding lens
21
A1