List Of Pictograms Used Introduction; Intended Use - Parkside PSGS 120 A1 Bedienungs- Und Sicherheitshinweise

Compressed argon
Direct current
U
Rated value of the mains
1
voltage
4-IN-1
COMPACT WELDER
PSGS 120 A1
z Introduction
Congratulations!
You have purchased
one of our high-quality devices. Please
familiarise yourself with the product
before using it for the first time. To do
so, please read through the following
operating and safety instructions care-
fully. This tool must be set up or used
only by people who have been trained
to do so.
KEEP OUT OF THE REACH OF
CHILDREN!
z Intended use
The device is designed for flux-cored
welding, MMA welding (welding with
rod electrodes) and TIG welding (tung-
sten inert gas welding). When using
flux-cored wires which do not contain
inert gas in solid form, then you must
use inert gas in addition. When using
the 0.95 l argon gas cylinder delivered
with the product, you can weld with
inert gas for a short period of time
even without external inert gas supply
(depending on the gas flow which is
set, approx. 6 to 10 minutes). When
using an external inert gas source, you
will need a separate pressure regulator
List of pictograms used / Introduction
Gas under pressure
U
Rated value of the open
0
circuit voltage
and adapter (neither of which are
included with the delivery). When using
self-shielding flux-cored wire, you do not
need to use any additional gas. In this
case, the protective gas is contained in
powder form in the wire itself, thus it is
fed directly into the arc. This means the
device is not susceptible to wind and
can be used outside. Only suitable wire
electrodes may be used for the device.
This welding device is designed for
manual arc welding (MMA welding)
of steel, stainless steel, steel sheet,
galvanised metal and cast materials,
using the appropriate coated electrodes.
Refer to the information from the
electrode manufacturer and the MMA
torch stand manufacturer. Only suitable
electrodes may be used for the device.
For tungsten inert gas welding (TIG
welding) it is essential that you observe
the operating and safety instructions for
the TIG torch you are using, in addition
to the instructions and safety instructions
in these operating instructions. If it is
not handled properly the product can
be dangerous for individuals, animals
and property. The welding mask must
only be used with protective welding
glasses as well as prescription glasses
which are marked appropriately, used
properly and as a general rule, are only
used for welding. The welding mask
is not designed for laser welding! Use
the product only as described and only
for the specific applications as stated.
Keep these instructions in a safe place.
Ensure you hand over all documentation
when passing the product on to anyone
GB/IE 35